Kukko K-22-C-E Bearing Extracting Set With Counterstay and Slide Hammer (Bore Range - 3/16" to 1 3/8")
Segmented internal bearing extractors are used for extracting bearings, bearing outer rings and bushings that lay flat against housings with little to no space behind the bearing. If there is 1/16" or more space behind the bearing, a standard extractor is recommended (no E suffix) Bore ranging from 3/16" to 1 3/8" or 4.8mm to 34mm.
Description
- The segmented design with extra fine grasp edges ensures safe extraction of bearings with no space behind the bearing
- Internal extractors can be used with the included slide hammer or counterstay for operation
Contents:
Internal Extractors - 21-0-E, 21-00-E, 21-01-E, 21-1-E, 21-2-E, 21-3-E and 21-4-E
Slide Hammer - 22-0
Counterstay - 22-1 with adapter M7 / M10
Other sets available - here
Advantage
- Practical package for universal use.
- Thanks to the Kukko modular system, the counterstay and the sliding hammer can be combined and subsequently completed with segmented internal extractors, needle bearing extractors, threaded inserts, etc.
- The arms on the counter supports are easy-to-adjust thanks to an internal spring mechanism. (size 1 to 3)
How it works
- Screw the internal extractor or the threaded insert into the component.
- For removal, the spindle on the counter support is screwed onto the internal extractor or the threaded pin.
- Counter support's arms must not block the part due to be removed. Make sure that the arms are parallel.
- Hold on to the T-grip and at the same time use the jaw wrench to tighten the nuts above the cross-beam until the component has been loosened from its position.
- For removal, the threaded rod on the slide hammer is screwed onto the key spindle on the internal extractor or threaded insert using the adapter.
